Boost: Black Edition Support
The Dr. Dabber Boost: Black is the first portable, battery-powered dab rig for essential oils, employing a domeless nail much like you would see in traditional glass dab rigs. There is no torch required. The device heats to an optimal temperature with a simple button press, making it one of the easiest dabbing solutions available. When attached to the included glass water filtration piece, the Boost replicates the dabbing experience perfectly. The Boost: Black truly is the best of both worlds: a portable dabbing experience without any sacrifice.
*Unfortunately, we no longer carry or cover the OG model of Boost unit under our warranty. Boost Black units are fully covered.*
Boost: Black Edition Basics
Boost: Black Heating:
Titanium Nail- 3 Click heat setting-White for 25 seconds, any time after turning Blue you may add your product.
Quartz & Ceramic Nails- 5 Click heat setting-Blue for 40 seconds, any time after turning White you may add your product.
You may turn the unit off at any time with 3 clicks.
Boost: Black Temperatures:
3 click: 450-550 on low heating cycle (white light, blue when temp is reached)
5 click: 550-650 on high heating cycle (blue light, white when temp is reached)
*varying on nails
Give your battery a full charge prior to using. Insert the Micro USB charger into the side of the Boost: Black, then insert the other side of the charger into a USB port or AC adapter. The power button shows a purple light when the device is being charged. A green light indicates charging is complete. Due to the size of the battery, it is recommended to charge 6-8 hours or overnight on an AC adapter to charge fully.
Try to remove the charging cord as soon as the unit is fully charged. The charging cord will not stop the trickle down effect, meaning it will slowly start to lose power over time after a full charge, while plugged in. You can always unplug and plug the unit back in to check if it needs a few more minutes for a full charge.
We offer 3 nails that can be used with your Boost: Black. We recommend using the Boost: Black Titanium nail with the 3 click heat setting-White for 25 seconds any time after turning Blue you can add your product.
And recommend using the Boost: Black Quartz nail // Ceramic nail -with the 5 click heat setting-Blue for 40 seconds any time after turning White you can add your product.
The ceramic heating rod is a replacement component for the Boost: Black. This unit requires this component in order to function. Heating rod // Heating rod (serial)
Disclaimer: Before purchasing the Serial Replacement Heating Rod, verify that your Boost: Black has a serial number printed on the unit. The serial number can be found on the back of your unit below the charging port.
Our standard glass is factory made whereas our custom glass is handmade borosilicate glass, made in the USA by our resident glassblowers. The custom pieces are aimed more towards the connoisseur, although both types of glass function equally well.
If you need a bit more heat (especially for the quartz nail) you may run a pre-heat cycle before adding your product. To do this, run the unit through a heating cycle then immediately turn the unit back on and dab on the 2nd heating cycle.
A new ceramic heating rod will usually solve any issues with the Boost: Black unit. An extra ceramic heating rod is included with your kit and more may be purchased online. Your heating rods should last you about 3-6 months depending on usage.
You may also unscrew your battery from the housing to inspect the battery for any possible imperfections or wear/tear.
Feel free to check out our instruction videos by visiting our Dr. Dabber YouTube Channel or follow us on Instagram, Twitter, and Facebook.
Thanks for the feedback There was a problem submitting your feedback. Please try again later.Boost: Black Edition Boost Introduction The Dr. Dabber Boost: Black is the first portable, battery-powered dab rig for essential oils, employing a domeless nai ]]>