pax 3 flashing white on charger

Pax Vaporizer Secrets and Tricks – Pax 2 & Pax 3 Vapes NZ

Get even more out of your PAX Vaporizer NZ.


Answer : Yes.

Spin Technique

Holding the Pax 2 horizontally in front of you spin it smoothly three times towards or away from you to change modes. Be careful not to shake the Pax 2, this will not register as a spin and throw your count off. The below modes are listed in the order they show up. It’s easier to count spins in successful cycles of 3 than in total. Therefore Simon is five cycles of three spins, instead of 15 spins in total. If you try to keep count you’ll constantly find that you’ll need to add a few extra spins because it’s difficult to make every spin count.

Party Mode

All four lights are different and cycle through different colors. There appears to be a rhythm/pattern to the color cycle. Lip sensor activation increases speed of color change. Oven is on. Standby timer extended to one minute between sensing movement or lip.

Party Timer

All four lights are stationary. When the Pax 2 is moved the lights jump into a random light configuration, occasionally one or more of the lights are very dim or off. If the Pax 2 is held face down the lights flicker and change rapidly. Lip sensor activation makes the lights flicker and change rapidly for up to 10 seconds. At 10 consecutive seconds of lip sensor activation the lights freeze. Removing your lips and replacing them starts another 10 second flicker display. Oven is on. Standby disabled.

Light Painting

In this mode all four lights show the same color and cycle through colors while the Pax 2 is being moved, when still, the lights are off. Waving the Pax 2 through the air yields a color changing stream of light. The heater can be turned off in this mode by selecting a fifth available temperature, all four lights blue.

Color Carousel

The lights react to movement and position of the Pax 2. When laid flat the Pax 2 shows blue. When face down, an orangish-yellow. When I hold the Pax 2 upright and give it a little circular flick, the colors begin to cycle with a noticeable pattern. The colors can be seen transitioning from one light to the next, as if there is a big globe of colors inside and the lights reflect whichever colors face forward. The heater can be turned off in this mode by selecting a fifth available temperature, all four lights blue.


Spin the Pax 2 until all four lights flash white three times. The Simon game will begin. Hold the Pax 2 face up, horizontally in front of you. Observe the pattern displayed on the lights, then repeat the sequence by leaning the Pax 2 towards the appropriate light. The heater can be turned off in this mode by selecting a fifth available temperature, all four lights blue.

Funky Town Tone

Pax 2 faintly plays the tune to Funky Town when it turns on. You can hear it if you’re within a few inches of the Pax 2 when it plays. Difficult to hear unless you’re listening for it. To unlock this feature beat a 20 step sequence in the Simon game. The Pax 2 will confirm unlock by flashing the four lights red, blue, green, and yellow and playing the Funky Town tune. To disable the tone simply go into the temperature settings and press the button five times quickly. The Pax 2 will confirm by flashing the four lights red, blue, green, and yellow.

Green Mode

Activating this mode causes the petals to flash a green pattern which moves back and forth. One thing to keep in mind is that you need to roll your Pax 2 three times in the opposite direction to enable it, unlike the rest of the Easter Eggs!

Stealth Mode

Although not technically a secret feature, stealth mode comes in really handy in certain situations so I thought that I’d share it. To activate stealth mode, simply shake your device while its displaying the startup pattern. Stealth mode will keep your Pax 2’s LEDs at a dim white for the duration of your session. To turn off stealth mode, simply turn your device off and then back on. I find stealth mode is great to use while I’m vaping before bed as well as in other places where low light is desirable.

Buy Best Portable Dry Herb Vape NZ.

Check out our Pax 2 and Pax 3 Vaporizers, we always have the latest colors when they are released in USA. Pax is our specialty brand, we have been importing & selling Pax in New Zealand and Australia since 2008.

Buy Pax 2 Vape NZ | Buy Pax 3 Vape NZ

Yes, we still sell Pax 2 and they are awesome! If you want a Pax and can’t afford a Pax 3, do not fear, the Pax 2 is still a great vape to buy. Highly recommended by Helenskinz.

Get even more out of your Pax Vape NZ. Unlock all the hidden features in your Pax Vaporizer. Spin Technique Holding the Pax horizontally in front of you spin it.. all the secrets revealed! Helenskinz NZ your Pax Specialist.

Pax 3 flashing white on charger

All I could find

Apparently, two blinking blue lights (in my case the top left and bottom right one) and subsequent self-power-down mean there’s something wrong with the pax 3 and it has to be sent in.

Mine’s done that a few times recently – but I could always just turn it back on so far – so I’m afraid it might stop working soon or something.
I should finally send in my old pax 2 (and when I received a replacement, my pax 3). 😆

Why, what could the app possibly do about this?
I mean I have the app and had connected it once to try it out, but later it wouldn’t find my pax 3 anymore.

Anyway, probably a good idea to send my pax 2 in first (that also came with a 10-year-warranty, right?) and then other one.

Main reason I posted here was to add what the blinking blue lights mean since I had just read about them and found this thread via google.
Plus I hadn’t heard about resetting the pax 3 before reading that reddit either, which I immediately tried. 🙂

Title kind of says it all… I can't find any lists of the light patterns and their meanings. Sometimes, my pax3 does the heating up pattern in pink, not purple. Sometimes it flashes the left 2 petals in a darkish blue, then shuts off and won't do anything but flash those lights and shut off, until…